There's a lot of unhappy people out there (like me) whos H100 (or H80 because of the same pump) is making a 1990's hard-drive noise.
For a long time this was believed to be caused be caused by air bubbles in the system. The only recommended solutions were to get it replaced by Corsair, or to shake the cooler while it's working, until the noise goes away.
Recently someone discovered that ts actually caused because some PSUs give a little more than 12 V. his causes the pump to work faster than it should. Like at 2300 RPM instead of 2000.
The new recommended solutions include:
Use something like a fan controller that has an extra molex for the pump or something.
I have yet to try any of this, as I just found out about it. I'll try to get some fan speed measuring program first to see how fast my pump is.
Maybe I could just use a molex to 3 pin adapter (which I already have) and use that to plug the pumps molex right into one of the PWMs on my motherboard? The case fans are meant to work at up to 12V, right? Or maybe this would be bad, because the motherboard measures its temperatures and only turns those up to full when it thinks its hot? Either way, I have some experimenting to do.
I could get a fan controller, but I'm trying not to have to do that, because 2 of the case fans use molexes and I don't want my whole case to become full of adapters and extension cords.
According to "SpeedFan", the pump is working at 2165 to 2181 rotations per minute. According to the people at the Corsair support forum, most of their pumps became quiet at about 1700 RPM.
According to the "CPU Thermometer" (by Microsoft), the cores are between 24 °C and 30 °C at idle. The stock cooler kept them at about 32 to 37 °C at idle.
Turns out that the molex to 3 pin adapter I have has the wrong (male) 3 pin part. (Duh! ) So all actual tests will have to wait.
Edited again for spelling.
Thread Recap (last 10 posts from newest to oldest)
Nov 11, 12 at 1:16pm
Ok mate , ive not had anything back as yet. thanks
Nov 09, 12 at 12:39pm
Ren of Heavens
Managed to find some 1N4001's today, so yeah if you don't hear anything back from RAM GUY I'll make a cable for you.
I'm sure he gets a lot of messages though, so probably best to give him a few days to respond.
Nov 07, 12 at 2:32pm
Would you be able to do that ? i would be really gratefull if you could help. Maybe add me on steam Cabbage4321
thanks. No one has got back to me as yet.
Nov 07, 12 at 5:25am
Ren of Heavens
If you don't get anywhere with that drop me a PM, I'm pretty certain I have some diodes lying around and can make you a cable.
I'm also in the UK so it'll cost barely anything to send
Nov 07, 12 at 4:25am
They wont pay for my postage and it would be a silly amount to send, and i cant afford it. I have emailed RAMGUY, hope they can help
"Corsair has now tracked down and fixed a rare and hard to reproduce issue on some of our Hydro series coolers, specifically the H60, H80, and H100 when used in combination with certain power supplies in certain circumstances. The failure will present itself as a buzz or hum, similar to a hard drive seek noise, and may disappear and reappear at random times. This issue affects a very small number of units, and typically is more prevalent on power supplies that provide higher than +12.2V on the +12V rail, which explains why some users have experienced multiple units with the same issue – they’re plugging them into the same power supply.
Regardless, this has since been corrected and we are now shipping units that do not experience the issue. If you’ve got a noisy H100, H80, or H60 unit, and the noise is coming from the pump (not the fans), we’d like to offer you a RMA. Please Contact us by using the link on the left and request an RMA to start a replacement with a known good unit.
Thank you, and we appreciate your patience as we corrected this issue."
Nov 05, 12 at 5:29am
I am completely skint, is there anyone that could possible send me a cable to lower the griding noise, i know thats alot to ask for, but i just don't have the money.
Hope someone can help
Or can someone add me on steam and tell me exactly what i need to get??? im in the uk
Good question. There's no wattage listed anywhere, but I just found someone at the Corsair support forum, who had measured that the pump gets 1.1 to 1.2 A and he claims that it works "fine" on his 1A 12W motherboard fan connector.
If the 7 W is not good enough, I'll just use the controller for fans and connect the pump to the motherboard. My motherboard fan connectors are good for up to 24 W and 2 A.
So either way, this will become super quiet, as I'll also be getting some of Corsairs new quiet edition fans.
Strange coincidence that this video should now show up, but I'll still use my first plan.