nice review ' Thanks
I love this card at first sight. Gigabyte done very good job

Nem-=> Thanks dude!

Jeff17 -=> This is the only HD3870 with DDR3 as far as I know.
Also, the Powercolor HD3850 Xtreme PCS that was used in the benchmarks is a factory-overclocked, super-charged HD3850 that uses DDR4 memory. So, it is sort of a reverse match-up of what you might normally see... it is a bit surprising how close the two came in the benchmarks. The low memory clock of the Gigabyte 3870 definitely does not help the cards performance -- but this can be overcome by a reasonable overclock.

Here's an old post about the differences between GDDR3 and GDDR4 (stolen from a forum):

GDDR3 vs GDDR4
1) 7.2 vs 11.2 GBps per chip max data speed
2) 1.8 vs 2.8 GBps per pin max data rate
3) 1.8 vs 1.5 v minimum power consumption which results in a 20-25% energy savings
4) 2.1 vs 1.9 v maximum power for overclocking
5) 4 vs 8 bit burst length which allows more memory bandwidth and lower latency
6) no DBI vs DBI: Data Bus Inversion - it takes more energy to transfer 0s than 1s. When there are a lot of 0s to move, it will send them as 1s instead and then use DBI to signal that all those 1s needed to be flipped back to 0s. This is a power saving feature.
7) Three point voltage control via video card driver for fine tuning and overclocking

I haven't specifically tested for speed differences between GDDR3 and GDDR4 (hey not a bad idea for an article hmm..) but I can tell you, that it makes a significant difference, but not a HUGE difference. As in, the difference isn't big enough to make or break a card; it is only a small performance difference; but it is there.

Hi,

I'm a bit confused. The review said the Gigabyte 3870 card was quiet. It's anything but unfortunately. The fan stays on 100% all the time. This would have been a great card if the fan was temperature controlled.

The fan stays on 100% all the time. Atitool and Rivatuner do not change this (at least on mine). The fan is not terrible as fans go, but when you're used to adjusting the fan speed depending on the temperature then it is loud. My x1950pro with the Zalman already added was the best. Great cooling which only ramps up when you need. Quiet as anything for anything but games.

Have you dudes been using the Catalyst 8.10 drivers? With that release you can control fan speed.

Personally I haven't been using Cat 8.10; but that's what I've been reading.